page 8
8. Blade Assembly.
lock washer
motor
housing
blade
7. Canopy Assembly.
Locate 2 screws on underside of hanging bracket
and remove screw closest to the open end of the
hanging bracket. Partially loosen the other screw.
Lift canopy to hanging bracket. Place rounded
part of slotted hole in canopy over loosened screw
in hanging bracket and push up. Twist canopy to
lock. Re-insert screw that was removed and then
tighten both screws securely.
Slide canopy cover up to canopy, aligning
rounded part of slotted holes in canopy cover with
screwheads in bottom of canopy. Turn canopy
cover to the right (clockwise) until it stops.
hanging
bracket
canopy
screw
flat washer
blade screw
screw
canopy cover
WARNING
: To reduce the risk of serious bodily injury,
DO NOT use power tools to assemble the blades. If
blade screws are overtightened, blades may crack
and break.
Locate 6 blade screws, lock washers and flat washers
in one of the hardware packs. Place 1 lock washer and
1 flat washer (
in that order
) on a blade screw. Repeat
for each blade screw.
Turn blade so the side with the label indicating THIS
SIDE UP is turned turned toward the motor housing.
Raise blade to motor, aligning holes in blade with
corresponding holes in motor. Partially insert 2 blade
screws (along with the lock washers and flat washers).
Before securing screws permanently, repeat
procedure for remaining blades. Securely tighten all
screws only after all 3 blades have been attached.
NOTE
: Tighten blade screws twice a year.
