page 8
9. Light Kit Assembly (Optional). (cont.)
LED light kit
LED light kit
glass shade
motor
housing
fitter plate
Carefully arrange wiring within fitter plate. Align
slotted holes in LED light kit with loosened screws
in fitter plate. Twist LED light kit to lock. Re-insert
screw that was previously removed and tighten all
3 screws securely.
To attach glass shade
, align grooves on glass
shade with nodules on inside of LED light kit. Push
up gently on glass shade and then turn glass
shade to the RIGHT (clockwise) until it no longer
turns.
NOTE
: Pull down
VERY GENTLY
on glass shade to
make sure that glass shade is secure.
If you do NOT wish to use the light kit
,
align
grooves in metal cover with nodules inside LED
light kit. Push up on metal cover and then turn
metal cover to the
RIGHT (clockwise)
until it no
longer turns.
metal cover
motor
housing
dimmer
switch
wall control
wire
wire
wire
12V battery
10. Handheld Remote Control
Assembly.
IN ORDER TO USE THE HANDHELD REMOTE CONTROL,
PLEASE CONTINUE WITH SECTION 10 for remote control
assembly instructions. If you have already installed the
wall control but do
not
wish to use the handheld
remote control, please proceed to Section 11.
Gently pull on remote control cover to separate top
and bottom parts. [
Refer to
diagram 1
.
]
In order to use wall control as a handheld remote
control, cut each wire on wall control (that was not
previously used)--use wire cutters to cut off each
wire as close to the wall control as possible. [
Refer to
diagram 2
.
]
Install one 12-volt battery (included) in wall control.
[
Refer to
diagram 2
.
]
The dimmer switch (labeled
ON
and
D
) has been
pre-set to the "ON" position (
ON
). If you do not wish
to have dimming capability, please move the switch
to the "OFF" position (
D
). [
Refer to
diagram 2
.
]
[”Handheld Remote Control Assembly"
continued on next page.]
(top)
(bottom)
remote control
cover
diagram 1
diagram 2
I
II
IV
VI
III
V
