page 9
10. Handheld Remote Control Assembly. (cont.)
(
NOTE
: Make sure to align narrower ends of remote
control cover before closing.) Squeeze top and bottom of
remote control cover together until you hear a click at
each end, indicating that the remote control cover has
closed completely.
IMPORTANT
: Store the handheld remote control away
from excess heat or humidity. To prevent damage to
handheld remote control, remove the battery if remote
control will not be used for long periods.
CAUTION
: “DO NOT DISPOSE OF BATTERIES IN FIRE,
BATTERIES MAY EXPLODE OR LEAK.” - When disposing of
household alkaline batteries, it is best to check with your
local and state recycling or household hazardous waste
coordinators concerning the specifics of the program in
your area. You may also locate a recycling center by calling
1-800-8-BATTERY or 1-877-2-RECYCLE or visit
www.epa.gov/epawaste/index.htm or www.earth911.org
for more information.
WARNING
:
Choking Hazard
- Small parts. Keep battery
away from children.
wall
control
remote control
cover,
BOTTOM
post
hole
diagram 3
post hole
remote control
cover,
TOP
I
II
IV
VI
III
V
11. Automated Learning Process./Activating Code.
wall control
faceplate
(almond
or white)
I
II
IV
VI
III
V
OFF
ON
SET button
faceplate
(black)
handheld
remote control
I
II
IV
VI
III
V
OFF
ON
SET button
CAUTION
:
The wall and/or handheld remote control
can be programmed to multiple receivers or fans. If
this is not desired, turn wall switch off to any other
programmable receiver or fan.
Restore electrical power and then, if using wall
control, set slider switch on wall control to the
ON position. Within 60 seconds of turning on the
wall control, press and hold the fan
SET
button
on the wall control for 5 seconds or until light
blinks twice.
Turn power off again for at least 5 seconds
and
then turn power back on. Within 60 seconds of
restoring the power, press and hold the fan
SET
button on the handheld remote control for
5 seconds or until light blinks twice.
Test the light and fan functions to confirm the
learning process is complete--
see Section 13 on
the following page.
Select a faceplate (
almond or white
) and press
firmly onto front of wall control that was
previously installed to the outlet box on the wall.
[
Refer to
diagram 1
.
]
Attach
black faceplate
to front of handheld
remote control; press down firmly.
[
Refer to
diagram 2
.
]
diagram 1
diagram 2
