7
Step 7
For added security, attach safety cable from fan unit to "J" hook (S8) in
outlet box. Secure by looping zip tie (S9) through safety cable and "J"
hook. Tighten zip tie securely. Lift fan onto the mounting bracket (#1).
Turn housing until hanging ball seats itself into ball socket (listen for click).
NOTE
: Parts furnished will allow
you to install your fan at up to a 35
º
angle. Angles greater than 35
º
will
require a 45
º
angle adapter
(see dealer).
NOTE
: J Hook installation is a
Canadian requirement only.
Outlet Box (A)
Support Beam
Ceiling
Green Ground Wire
“J” Hook (S8)
OUTLET BOX
“J” Hook (S8)
Safety Cable
Zip Tie (S9)
Mounting Bracket
WARNING:
To reduce the risk of fire, electric shock or personal injury, mount
so outlet box marked "acceptable for fan support" and use mounting screws
provided with the outlet box. Most outlet boxes commonly used for the support
of lighting fixtures are not acceptable for fan support and may need to be
replaced. Consult a qualified electrician if in doubt.
Step 6
Position downrod so the hole in the downrod aligns with the hole in the
coupling on the motor. Insert safety bolt (S7) through coupling and
downrod and attach nut. Tighten firmly. Tighten set screw "A" against
downrod. Place top motor housing (4) over downrod assembly. Place
canopy (3) over downrod (2). Attach black antenna wire plug from top
motor housing to black antenna wire plug on motor housing. Make sure
connections are fully snapped together. Replace hanging ball, insert
hanging pin through downrod and tighten set screw "C" in hanging ball
into downrod.
6
Set Screw (C)
Black Antenna Wire
Safety Bolt & Nut (S7)
Set Screw (A)
Canopy (3)
Downrod (2)
Top Motor Housing (4)
Fan Motor Housing (5)
Ground
Wire
Ball
Screw
Hanging Pin
Hanging
Ball
Threaded Set
Screw Hole
WARNING:
Failure to completely tighten downrod as described in steps 5 &
6 above could result in the fan loosening and possibly falling.
IMPORTANT:
Black antenna wire must be connected for fan to function.
