WARNING
: Turn off circuit breakers to current fixture
from breaker panel and be sure switch is turned to the
OFF position.
CAUTION
:
Be sure outlet box is properly grounded and
that a ground wire (
GREEN
or Bare) is present.
Make sure all electrical connections comply with Local
Codes or Ordinances and the National Electrical Code. If you
are unfamiliar with electrical wiring or if the house/building
wires are different colors than those referred to in the
instructions below, please use a qualified electrician.
Note
:
Excess lead wire length from the fan can be cut
to the desired length and then stripped.
When downrod is secured in place on the hanging
bracket, electrical wiring can be made as follows:
Connect
BLACK
wire from fan to
BLACK
wire from
ceiling with wire connector provided.
Connect
WHITE
wire from fan to
WHITE
wire from
ceiling with wire connector provided.
Connect all
GROUND
(
GREEN
) wires together from fan
to
BARE
/
GREEN
wire from ceiling with wire connector
provided.
Since this fan does not come with a light kit, you will
need to cap off the
BLUE
wire with a wire connector
(as shown with arrow in diagram).
[
Note
: If you elect to purchase a light kit for the fan,
the
BLUE
wire from the fan must be connected to the
BLACK
(or
RED
) wire from the ceiling instead.]
* Wrap each wire connector separately with electrical
tape as an extra safety measure.
This fan is remote control adaptable (remote control sold
separately).
page 5
5. Fan Assembly. (cont.)
With the hanging bracket secured to the outlet box and able to
support the fan, you are now ready to hang your fan. Grab the fan
firmly with two hands. Slide downrod through opening in hanging
bracket and let hanging ball rest on the hanging bracket. Turn the
hanging ball slot until it lines up with the hanging bracket tab.
WARNING
: Failure to align slot in hanging ball with tab in hanging
bracket may result in serious injury or death.
Tip
: Seek the help of another person to hold the stepladder in
place and to lift the fan up to you once you are set on the ladder.
Find a secure attachment point (wood ceiling joist highly
recommended) and secure safety cable. It will be necessary to
use a heavy duty wood screw, washer and lock washer (not
supplied) with the safety cable loop. If necessary, adjust the loop
at the end of the safety cable. The loop at the end of the safety
cable should just fit over the threads on the wood screw.
Test
safety cable by pulling on loose end of cable with pliers. If the safety
cable slips, the loop must be adjusted tighter.
Extra cable slack can
be left in ceiling area.
hanging bracket tab
motor housing
safety
cable
safety cable loop
wood ceiling
joist
wood screw
and washer
6. Wiring.
wire
connector
black
black
white
white
blue
black supply wire
ground
(green
or bare)
white supply wire
from
ceiling
from
fan
ground
(green or bare)
*
hanging ball slot
