page 7
9. Switch Housing Assembly.
Loosen 3 screws on fitter plate (on underside of
motor housing). Connect male plug from motor
housing to female plug from switch housing,
matching up the colors on the male plug with the
colors on the female plug. Make sure plugs
connect tightly. Align slotted holes in top of
switch housing with loosened screws in fitter
plate. Twist switch housing to lock. Securely
tighten all 3 screws.
10. Testing Your Fan.
It is recommended that you test fan before
finalizing installation. Restore power from circuit
box and light switch (if applicable). Test fan speeds
with the pull chain on the switch housing. Start at
the OFF position (no blade movement). First pull
will set the fan to HI. Second pull will set the fan to
MEDIUM. Third pull will set the fan to LOW. Fourth
pull will again set the fan to the OFF setting
(
diagram 1
). If fan does not function, please refer
to "Troubleshooting" section to solve any issues
before contacting Customer Service.
Turn fan completely off
before
moving the reverse
switch. Set reverse switch to recirculate air
depending on the season:
- LEFT position in summer (
diagram 2
)
- RIGHT position in winter (
diagram 3
)
A ceiling fan will allow you to raise your
thermostat setting in summer and lower your
thermostat setting in winter without feeling a
difference in your comfort.
Important
: Reverse switch must be set either
completely LEFT
or
completely RIGHT
for fan to
function. If the reverse switch is set in the
middle
position (
diagram 4
), fan will not operate.
Attach pull chain extension supplied or custom
pull chain extension (sold separately) to end of the
pull chain.
switch
housing
fitter
plate
motor housing
male plug
female plug
pull chain
extension
diagram 1
diagram 2
diagram 3
diagram 4
reverse
switch
