page 5
With wider opening facing up, place housing ring over
top
of motor housing. Then, push housing ring down
past top edge of motor housing.
Lift motor housing to mounting plate and then hang
motor housing on j-hook on underside of mounting
plate. (Use one of the
non-slotted
holes on the rim of the
motor housing to do so.) This will allow motor housing to
hang out of the way while wiring.
Tip
: Seek the help of another person to hold the
stepladder in place and to lift the fan up to you once you
are set on the ladder.
Find a secure attachment point (wood ceiling joist highly
recommended) and secure safety cable. It will be
necessary to use a heavy duty wood screw, washer and
lock washer (not supplied) with the safety cable loop. If
necessary, adjust the loop at the end of the safety cable.
The loop at the end of the safety cable should just fit over
the threads on the wood screw
. Test safety cable by
pulling on loose end of cable with pliers. If the safety cable
slips, the loop must be adjusted smaller.
Extra cable slack
can be left in ceiling area.
5. Preparation for Wiring.
wood
joist
safety
cable
loop
wood screw
and washer
safety
cable
non-slotted
hole
j-hook
motor housing
housing ring
6. Wiring.
(wiring for receiver)
white supply wire
black supply wire
black
black
white
blue
blue
white
from receiver
black
AC IN L
AC IN N
white
whit
e
ground (green
or bare)
from fan
from receiver
antenna
from ceiling
receiver
ground
(green or bare)
WARNING
: Turn off circuit breakers to current fixture
from breaker panel and be sure switch is turned to the
OFF position.
CAUTION
:
Be sure outlet box is properly grounded and
that a ground wire (
GREEN
or Bare) is present.
Make sure all electrical connections comply with Local
Codes or Ordinances and the National Electrical Code. If
you are unfamiliar with electrical wiring or if the
house/building wires are different colors than those
referred to in the diagram to the right, please use a
qualified electrician.
Note
:
Excess lead wire length from the fan can be cut
to the desired length and then stripped.
Once motor housing has been temporarily hung on the
j-hook on the mounting plate, wire the
RECEIVER
with
wire connectors provided
as shown in diagram at right.
Tip
: While you are wiring, keep in mind that wires must
not obstruct receiver.
* Wrap each wire connector separately with electrical
tape as an extra safety measure.
Gently insert receiver (flat side up) into mounting plate
and carefully push wires and taped wire connectors into
outlet box. Let antenna rest
outside
of mounting plate.
["Wiring" continued on next page.]
black
