page 7
8. Blade Assembly.
7. Canopy Assembly.
Locate 2 screws on underside of hanging bracket
and remove screw closest to the open end of the
hanging bracket. Partially loosen the other screw.
Lift canopy to hanging bracket. Place rounded
part of slotted hole in canopy over loosened
screw in hanging bracket and push up. Twist
canopy to lock. Re-insert screw that was removed
and then tighten both screws securely.
Slide canopy cover up to canopy, aligning
rounded part of slotted holes in canopy cover
with screwheads in bottom of canopy. Turn
canopy cover to the right (clockwise) until it stops.
hanging
bracket
canopy
screw
canopy cover
screw
WARNING
: To reduce the risk of serious bodily
injury,
DO NOT use power tools to assemble the
blades. If screws are overtightened, blades may
crack and break.
Remove the 10 blade attachment
screw/washers from the outer edge on the
underside of the motor housing.
Raise blade to motor, aligning holes in blade
with corresponding holes in motor.
[
Be sure to
note label on blade indicating
THIS SIDE UP
and
turn blade so that label faces up
]. Hold 1 blade
plate up to a blade, placing the flat side of the
blade plate against the blade, and align holes as
shown. Insert 2 blade attachment
screws/washers from
UNDERSIDE
of blade with
fingers first and then tighten screws securely
with a Phillips screwdriver. Repeat procedure for
remaining blades.
Note
: Tighten blade attachment screws twice a
year.
blade
motor housing
blade attachment
screws/washers
blade plate
