page 6
5. Fan Assembly. (cont.)
safety cable
hanging bracket tab
hanging ball slot
wood ceiling
joist
wood screw
and washer
safety cable loop
With the hanging bracket secured to the outlet box and
able to support the fan, you are now ready to hang your
fan. Grab the fan firmly with two hands. Slide downrod
through opening in hanging bracket and let hanging ball
rest on the hanging bracket. Turn the hanging ball slot
until it lines up with the hanging bracket tab.
WARNING
: Failure to align slot in hanging ball with tab in
hanging bracket may result in serious injury or death.
Tip
: Seek the help of another person to hold the
stepladder in place and to help lift the fan up to you once
you are set on the ladder.
Find a secure attachment point (wood ceiling joist highly
recommended) and secure safety cable. It will be
necessary to use a heavy duty wood screw, washer and
lock washer (not supplied) with the safety cable loop. If
necessary, adjust the loop at the end of the safety cable.
The loop at the end of the safety cable should just fit over
the threads on the wood screw.
Test safety cable by pulling
on loose end of safety cable with pliers. If the safety cable
slips, the loop must be adjusted smaller.
Extra cable slack
can be left in ceiling area.
6. Wiring.
motor housing
6. Wiring.
WARNING
: Turn off circuit breakers to current
fixture from breaker panel and be sure switch is
turned to the OFF position.
CAUTION
:
Be sure outlet box is properly grounded
and that a ground wire (
GREEN
or Bare) is present.
Make sure all electrical connections comply with
Local Codes or Ordinances and the National
Electrical Code. If you are unfamiliar with electrical
wiring or if the house/building wires are different
colors than those referred to in the diagram to the
right, please use a qualified electrician.
Note
:
Excess lead wire length from the fan can be
cut to the desired length and then stripped.
When downrod is secured in place on the
hanging bracket,
WIRE THE RECEIVER
with wire
connectors provided
as shown in diagram at
right.
Tip
: While you are wiring, keep in mind that
wires must not obstruct receiver from sliding
into hanging bracket.
* Wrap each wire connector separately with
electrical tape as an extra safety measure.
Gently insert receiver (flat side up) into hanging
bracket and carefully push taped wire
connectors into outlet box. Let antenna rest
outside
of hanging bracket.
ground (green
or bare)
white supply wire
black supply wire
from receiver
black AC IN L
AC IN N
white
white
ground (green or bare)
ground (green/yellow)
antenna
from ceiling
receiver
black
*
ground (green)
blue
blue
white
white
pink
pink
yellow
yellow
gray
gray
(wiring for receiver)
from
receiver
from fan
