page 5
5. Fan Assembly (with downrod). (cont. )
With the hanging bracket secured to the outlet box and
able to support the fan, you are now ready to hang your
fan. Grab the fan firmly with two hands. Slide downrod
through opening in hanging bracket and let hanging
ball rest on the hanging bracket. Turn the hanging ball
slot until it lines up with the hanging bracket tab.
WARNING
: Failure to align slot in hanging ball with tab
in hanging bracket may result in serious injury or death.
Tip
: Seek the help of another person to hold the
stepladder in place and to lift the fan up to you once
you are set on the ladder.
Continue to "Wiring" section for wiring diagram.
6. Fan Assembly (flushmount).
canopy
canopy cover
Remove and set aside canopy cover to reveal
6 holes. Notice that 3 of these holes are larger
than the others.
If there are only
3
screws in top of motor housing,
please proceed to next paragraph. If there are
6
screws in top of motor housing, remove every
other screw and lock washer.
Thread wiring through canopy. Place canopy over
yoke, aligning larger holes in canopy with the
3 existing screws in top of motor housing. Insert
the 3 screws and 3 lock washers that were
removed (if there were only 3 screws located in
top of motor housing, these screws/lock washers
will be located in one of the hardware packs) into
the remaining holes. Securely tighten these
screws.
To prepare the fan for wiring, hang fan onto
hanging bracket by sliding the canopy over the
hanging bracket tab. (Use one of the non-slotted
holes on the rim of the canopy to do so.)
canopy
motor housing
yoke
canopy
motor housing
hanging
bracket tab
hanging ball slot
hanging bracket tab
