page 7
7. Wiring.
CAUTION
:
Be sure outlet box is properly grounded
and that a ground wire (
GREEN
or Bare) is present.
Make sure all electrical connections comply with
Local Codes or Ordinances and the National
Electrical Code. If you are unfamiliar with electrical
wiring or if the house/building wires are different
colors than those referred to in the instructions
below, please use a qualified electrician.
Note
:
Excess lead wire length from the fan can be
cut to the desired length and then stripped.
When fan is secured in place on the hanging
bracket, electrical wiring can be made as follows:
Connect
BLACK
and
BLUE
wires from fan to
BLACK
wire from ceiling. Connect
WHITE
wire
from fan to
WHITE
wire from ceiling. Connect all
GROUND
(
GREEN
) wires together from fan to
BARE
/
GREEN
wire from ceiling.
Use wire
connectors provided when making connections.
If you intend to control the fan light with a
separate light switch connect
BLUE
wire from fan
to the
BLACK
(or
RED
)
supply from the
independent switch.
* Wrap each wire connector separately with
electrical tape as an extra safety measure.
This fan is remote control adaptable (remote control
sold separately).
white
black supply wire
white supply wire
ground
(green or bare)
*
ground
(green
or bare)
from fan
black
white
blue
black
from ceiling
8. Canopy Assembly.
Temporarily raise canopy to hanging bracket to
determine which 2 screws in hanging bracket align
with
slotted
holes in canopy, and then lower
canopy and
partially loosen
these 2 screws.
Remove
the
other
2 screws/lock washers and set aside.
Now, lift canopy to hanging bracket again, aligning
slotted holes in the canopy with loosened screws in
hanging bracket. Twist canopy to lock. Re-insert the
other 2 screws/washers and secure all screws with
a Phillips screwdriver.
canopy
hanging bracket
slotted
hole
