page 6
7. Fan Assembly.
Without removing motor assembly from
j-hook, slide motor assembly over mounting
plate, aligning holes in top plate of motor
assembly with screws in mounting plate.
Re-insert the 4 flat washers and 4 lock nuts
previously removed (page 4, Section 4) to
secure motor assembly. Tighten all 4 lock
nuts.
[
Refer to
diagram 1
.
]
Note
: Make sure wires and wire connectors
do not get tangled or pinched between the
plates.
Raise motor housing to mounting plate,
aligning 4 metal bars on the inside edge of
motor housing with 4 posts on edge of
mounting plate . Twist motor housing to the
RIGHT to lock.
[
Refer to
diagram 2
.
]
WARNING
: It is important that you make
sure to turn the motor housing
all the way to
the right
to ensure that the motor housing is
completely secure.
Remove 5 screws/washers from underside of
motor assembly. Align holes in center band
with screw holes in motor assembly, allowing
the male plug from motor assembly to come
through hole in middle of center band.
Re-insert screws/washers just removed and
securely tighten all 5 screws/washers with a
Phillips screwdriver.
[
Refer to
diagram 3
.
]
diagram 3
mounting plate
motor assembly
diagram 1
flat washers
lock nuts
motor
housing
mounting plate
post
metal
bars
(
inside
)
diagram 2
motor assembly
center band
male plug
