page 7
7. Canopy Assembly.
8. Blade Assembly.
Locate 2 screws on underside of hanging
bracket and remove screw closest to the open
end of the hanging bracket. Partially loosen the
other screw. Lift canopy to hanging bracket.
Place rounded part of slotted hole in canopy
over loosened screw in hanging bracket and
push up. Twist canopy to lock. Re-insert screw
that was removed and then tighten both
screws securely.
Slide canopy cover up to canopy, aligning
rounded part of slotted holes in canopy cover
with screwheads in bottom of canopy. Turn
canopy cover to the right (clockwise) until it
stops.
WARNING
: To reduce the risk of serious
bodily injury,
DO NOT use power tools to
assemble the blades. If overtightened,
blades may crack and break.
Time Saver
: Washers for blade screws can
be set on each blade screw prior to
installing blades.
Locate 12 blade attachment screws and
washers in hardware pack. Slide blade
through one of the narrow, rectangular
openings on motor housing, aligning holes
in blade with holes in blade arm (
located
on the underside of the motor
housing
)--
refer to drawing at right
. Insert 3
blade attachment screws (along with
washers) with fingers first and then tighten
screws securely with a Phillips screwdriver.
Repeat procedure for each remaining
blade.
Note
: Tighten blade attachment screws
twice a year.
hanging
bracket
canopy
screw
blade
motor housing
blade
arm
blade attachment
screws and washers
screw
canopy cover
