page 7
8. Blade Assembly.
7. Canopy Assembly.
antenna
receiver
canopy
hanging bracket
Temporarily raise canopy to hanging bracket to
determine which 2 screws in hanging bracket
align with
slotted
holes in canopy, and then lower
canopy and
partially loosen
these 2 screws.
Remove
the
other
2 screws and set aside.
Now, lift canopy to hanging bracket again,
aligning slotted holes in the canopy with
loosened screws in hanging bracket. Twist canopy
to lock. Re-insert the other 2 screws and secure all
screws with Phillips screwdriver.
motor
housing
blade
blade arm
blade attachment
screws and washers
Time Saver:
Washers for blade screws can be
set on each blade screw prior to installing
blades.
Locate 9 blade attachment screws and
washers in one of the hardware packs. Place
blade on top of blade arm, aligning holes in
blade arm with holes in blade as shown.
Insert 3 blade attachment screws (along with
washers) with fingers first and then tighten
screws securely with Phillips screwdriver.
Repeat procedure for remaining blades.
Note
: Tighten blade arm screws twice a year.
