page 7
(wiring for wall control)
black
(TO POWER SUPPLY)
black
(AC IN from
breaker box)
green/
green/
bare
bare
ground
ground
green/
bare
ground
outlet box
wall control
plate
6. Wiring. (cont.)
Modifications not approved by the party responsible for compliance
could void the user's authority to operate the equipment.
*NOTE: This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to
radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to
radio
or television
reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
* Reorient or relocate the receiving antenna.
* Increase the separation between the equipment and receiver.
* Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
green with yellow
stripe (GROUND)
7. Canopy Assembly.
Locate 2 screws on underside of hanging
bracket and remove screw closest to the open
end of the hanging bracket. Partially loosen
the other screw. Lift canopy to hanging
bracket. Place rounded part of slotted hole in
canopy over loosened screw in hanging
bracket and push up. Twist canopy to lock.
Re-insert screw that was removed and then
tighten both screws securely.
Slide canopy cover up to canopy, aligning
rounded part of slotted holes in canopy cover
with screwheads in bottom of canopy. Turn
canopy cover to the right (clockwise) until it
stops.
screw
hanging
bracket
canopy
IN ORDER TO WIRE WALL CONTROL
,
remove existing wall switch. Wire the
wall
control with wire connectors provided
as
shown in diagram at right.
WARNING
:
CONNECT WIRES IN THE
FOLLOWING ORDER ONLY!
Connect
GREEN
wire
with YELLOW STRIPE
(ground) from wall control to ground from
house or directly to one of the screws from
the outlet box.
Connect
BLACK
wire from wall control to
BLACK
(hot) lead wire from house.
Connect
BLACK
wire from wall control to
BLACK
load wire to fan.
* Wrap each wire connector separately with
electrical tape as an extra safety measure.
Gently push wires and taped wire
connectors into outlet box.
Attach wall control to outlet box and secure
with screws from original wall switch. Attach
front plate to wall control using 2 screws
provided in the wall control.
canopy cover
screw
BLACK
BLA
CK
(TO MO
TOR)
