page 9
9. LED Light Kit Assembly.
LED light kit
motor housing
motor plate
fitter plate
LED light kit
molex
connections
motor housing
fitter plate
shade
grooves
metal cover
grooves
motor housing
nodules
nodules
Remove 1 screw from motor plate on underside of
motor housing and partially loosen the other 2
screws. Align slotted holes in fitter plate with
loosened screws in motor plate, allowing molex
connections from motor housing to come through
holes in middle of fitter plate. Twist fitter plate to
lock. Re-insert screw that was just removed and
securely tighten all 3 screws with a Phillips
screwdriver.
Remove 1 screw from from underside of fitter plate
and partially loosen the other 2 screws.
Connect
WHITE
wire from LED light kit to
WHITE
wire from motor housing. Connect
BLACK
wire
from LED light kit to
BLACK
(or
BLUE
) wire from
motor housing. [
NOTE
: It may be necessary to
push back sleeve on wires to be certain of wire
colors.] Be sure that molex connections snap
together completely.
Carefully arrange wiring within fitter plate. Align
slotted holes in LED light kit with loosened screws
in fitter plate. Twist LED light kit to lock. Re-insert
screw that was previously removed and tighten all
3 screws securely.
Align grooves on shade with nodules on inside of
LED light kit and push up gently on shade. Twist
shade to the RIGHT (clockwise) until shade locks
into place. Pull down VERY GENTLY on shade to
make sure that shade is secure.
If you do NOT wish to use the light kit
, l
ocate slots
on metal cover and align with nodules inside
LED
light kit
. Gently push up on metal cover and turn
to the
RIGHT (clockwise)
until it no longer turns.
WARNING
: Metal cover will be HOT if light is left
on.
