page 8
8. Blade Assembly.
7. Canopy Assembly.
Locate 2 screws on underside of hanging bracket
and remove screw closest to the open end of the
hanging bracket. Partially loosen the other screw.
Lift canopy to hanging bracket. Place rounded
part of slotted hole in canopy over loosened
screw in hanging bracket and push up. Twist
canopy to lock. Re-insert screw that was removed
and then tighten both screws securely.
Slide canopy cover up to canopy, aligning
rounded part of slotted holes in canopy cover
with screwheads in bottom of canopy. Turn
canopy cover to the right (clockwise) until it stops.
hanging
bracket
canopy
screw
canopy cover
screw
WARNING
: To reduce the risk of serious bodily
injury,
DO NOT use power tools to assemble the
blades. If blade attachment screws are
overtightened, blades may crack and break.
Locate 6 blade attachment screws in one of the
hardware packs.
Raise 1 blade to motor making sure to note
label on blade indicating THIS SIDE UP. Then
align holes in blade with corresponding holes in
motor.
Hold 1 blade plate up to the blade and
align holes
as shown
. Insert 2 blade attachment
screws from
UNDERSIDE
of blade with fingers
first before securing screws permanently, repeat
procedure for remaining blades. Securely
tighten all screws only after all 3 blades have
been attached.
NOTE
: Tighten blade attachment screws twice a
year.
blade
motor housing
blade attachment
screws
blade plate
