page 7
9. Blade Assembly.
motor housing
blade arm
blade
blade attachment
screws and washers
blade arm
screws
lock washers
10. Light Kit Assembly (Optional).
switch housing
Time Saver:
Washers for blade screws can be set
on each blade screw prior to installing blades.
Locate 15 blade attachment screws and washers
in hardware pack. Hold blade arm up to blade and
align holes. Insert 3 blade attachment screws
(along with washers) with fingers first and then
tighten screws securely with a Phillips screwdriver.
Repeat for the remaining blades.
Remove blade arm screws and lock washers from
underside of motor. If plastic motor locks are
installed with blade arm screws, discard plastic
motor locks (
save blade arm screws and lock washers
to secure blade arms
). Align blade arm holes with
motor screw holes and attach blade arm with lock
washers and blade arm screws. Before securing
screws permanently, repeat this procedure with
remaining blade arms. Securely tighten all screws.
Note
: Tighten blade arm screws twice a year.
plastic
motor
lock
motor
housing
Remove 3 screws and star washers from switch
housing cap.
If you wish to use your fan WITHOUT the light kit,
align holes in switch housing cap with holes in switch
housing.
(
Note: The gap on the top edge of the
switch
housing cap must align with the reverse switch on the
switch housing for the proper fit.) Secure switch
housing cap with 3 screws that were just removed
.
Please
proceed
to Se
ction
11 on the following
page
to
complete installation without
light kit.
If you wish to use your fan WITH the light kit
,
locate
BLACK
(or
BLUE
) and
WHITE
wires in
switch housing labeled FOR LIGHT. Remove and
discard plastic that holds these 2 wires together.
Remove the hex nut and lock washer from threaded
rod in light kit fitter.
Punch center cap out of switch
housing cap with a screwdriver. Feed wires from
light kit fitter through center hole in switch
housing cap. Screw switch housing cap onto
threaded rod on light kit fitter followed by lock
washer and hex nut. Tighten hex nut over lock
washer for a secure fit.
["Light Kit Assembly" continued on next page.]
switch housing
cap
switch housing cap
hex nut
lock washer
light kit fitter
center cap
threaded
rod
