page 5
5. Fan Assembly (with downrod). (cont.)
hanging ball slot
hanging bracket tab
With the hanging bracket secured to the
outlet box and able to support the fan, you are
now ready to hang your fan. Grab the fan
firmly with two hands. Slide downrod through
opening in hanging bracket and let hanging
ball rest on the hanging bracket. Turn the
hanging ball slot until it lines up with the
hanging bracket tab.
WARNING
: Failure to align slot in hanging ball
with tab in hanging bracket may result in
serious injury or death.
Tip:
Seek the help of another person to hold
the stepladder in place and to help lift the fan
up to you once you are set on the ladder.
Continue to "Wiring" section on page 6 for
wiring diagram.
6. Fan Assembly (flushmount).
Remove and set aside canopy cover to reveal 6
holes. [
Refer to
diagram 1
.
] Notice that 3 of
these holes are larger.
If there are only
3
screws in top of motor
housing, please proceed to next paragraph. If
there are
6
screws in top of motor housing,
remove every other screw and lock washer.
Thread wiring through canopy. Place canopy
over yoke, aligning larger holes in canopy with
the 3 existing screws in top of motor housing.
Insert the 3 screws and 3 lock washers that had
been removed (if there were only 3 screws
located in top of motor housing, these
screws/lock washers will be located in one of
the hardware packs) into the remaining holes.
Securely tighten these screws. [
Refer to
diagram 2
.
]
canopy
canopy cover
canopy
motor housing
yoke
diagram 1
diagram 2
motor
housing
