page 6
5. Fan Assembly.
NOTE
:
The important safety precautions and
instructions appearing in the manual are not meant
to cover all possible conditions and situations that
may occur. It must be understood that common
sense and caution are necessary factors in the
installation and operation of this fan.
Remove hanging ball from downrod provided by
loosening set screw on hanging ball. Remove pin
and clip. Lower hanging ball and remove stop pin.
Then slide hanging ball off downrod.
[
Refer to
diagram 1
.
]
Remove vice from safety cable by loosening the
screw and nut on the vice. Loosen yoke set screws
and nuts at top of motor housing.
[
Refer to
diagram 2
.
]
Tip
: To prepare for threading electrical wires
through downrod, apply a small piece of electrical
tape to the ends of the electrical wires--this will
keep the wires together when threading them
through the downrod.
[
Refer to
diagram 2
.]
Determine the length of downrod you wish to
use. Thread safety cable and electrical wires
through threaded end of downrod and pull extra
wire slack from the upper end of the downrod.
[
Refer to
diagram 2
.
]
Thread downrod into the motor housing yoke
until holes for pin and clip in downrod align with
holes in yoke--make sure wires do not get twisted.
Re-insert pin and clip that were previously
removed. Tighten yoke set screws and nuts
securely. [
Refer to
diagram 2
.
]
Remove canopy cover from underside of canopy
by turning canopy cover counterclockwise. Slide
yoke cover, canopy cover and canopy over
downrod. [
Refer to
diagram 3
.
] (
Note
: Canopy
cover must be turned with shiny side toward the
motor housing.)
["Fan Assembly" continued on next page.]
downrod
electrical wiring
canopy
yoke cover
motor
housing
diagram 2
diagram 1
diagram 3
set screw
hanging ball
stop pin
pin
clip
canopy cover
vice
nut
screw
yoke set
screw
and nut
pin
clip
downrod
wiring
safety cable
safety cable
