12. Testing Your Fan.
It is recommended that you test fan before finalizing
installation. Restore power from circuit box and light
switch (if applicable). Test fan speeds with the pull chain
located to one side. Start at the OFF position (no blade
movement). First pull will set the fan to HI. Second pull
will set the fan to MEDIUM. Third pull will set the fan to
LOW. Fourth pull will again will set the fan to OFF
setting. Test light with pull chain in the middle
(
diagram 1
)
. If fan and/or light do (does) not function,
please refer to "Troubleshooting" section to solve any
issues before contacting Customer Service.
Turn fan completely off
before
moving the reverse
switch. Set reverse switch to recirculate air depending
on the season:
- LEFT position in summer (
diagram 2
)
- RIGHT position in winter (
diagram 3
)
A ceiling fan will allow you to raise your thermostat
setting in summer and lower your thermostat setting in
winter without feeling a difference in your comfort.
Important
: Reverse switch must be set either
completely to the LEFT
or
completely to the RIGHT
for fan
to function. If the reverse switch is set in the
middle
position (
diagram 4
), fan will not operate.
Pull chain extensions supplied or custom pull chain
extensions (sold separately) may be attached to the
ends of the pull chains.
diagram 2
diagram 3
diagram 4
fan
pull chain
extension
light
pull chain
extension
reverse switch
diagram 1
page 11
