page 10
1
--Fan
SPEED
control button(s):
Use to control the ceiling fan speed 1-6
2
--Fan
OFF
button:
Use to turn the fan off
3
--
REVERSE
function button:
Use to control fan direction
4
--
LIGHTING
button:
Use to control down-light and up-light (if applicable)
5
--
ON
/
OFF
slider switch:
[Wall control only] Use to turn wall control on or off
IMPORTANT:
Handheld remote
control and wall
control must be
SYNCHRONIZED with
fan in order to
properly function.
handheld
remote control
wall control
4
3
1
5
I
OFF
ON
II
III
IV
V
VI
2
14. Remote/Wall Control Operation.
I
II
IV
VI
III
V
4
1
2
3
15. Testing Your Fan.
It is recommended that you test fan before finalizing installation.
Restore power from circuit box and light switch (if applicable). Test wall
control (optional installation) by locating ON/OFF slider switch on wall
control, then set to the ON position. Test light function and test fan
speeds. Locate handheld remote control. Test fan speeds with the
different fan speed buttons (
I - VI
) on handheld remote control. Test
the light ON/OFF function by pressing the button. If the remote
control operates all of the functions of the fan/light, battery has been
installed correctly. If the wall and/or remote control do (does) not
operate all of the fan/light functions, refer to "Troubleshooting" section
to solve any issues before contacting Customer Service.
Fan
must
be on LOW
before
setting the fan in reverse. Use button
to recirculate air depending on the season. A ceiling fan will allow you
to raise your thermostat setting in summer and lower your thermostat
setting in winter without feeling a difference in your comfort.
NOTE
: If the wall control/handheld remote control interferes with other
appliances, activate a new code on the wall control/ handheld remote
control by
turning the power off first
. Go back to the instructions for
the SET button in Section 13 (page 9).
IMPORTANT
: Handheld remote control and wall control must be
synchronized with fan in order to properly function.
I
II
IV
VI
III
V
IMPORTANT
:
The Automated Learning Process takes approximately 5 minutes to complete.
Please
leave the fan “ON”
for the duration of the 5-minute programming and
do NOT use
the
remote control or turn the power off
during this time.
The fan will
cycle through ALL SIX (6) speeds in forward and reverse
and will
then stop
automatically
after the learning process is complete.
