1
1
-
DIM ON
page 6
7. Canopy Assembly.
Raise canopy to hanging bracket and align slotted holes
in canopy with loosened screws in hanging bracket. Twist
canopy to lock. Re-insert screws (along with star washers)
that were previously removed (page 3, Section 4) and
secure all screws with a Phillips screwdriver.
*Remember that antenna for remote control receiver
must rest
outside
of hanging bracket.
canopy
hanging
bracket
slotted hole
antenna
6. Wiring. (cont.)
[
PLEASE NOTE
: Wall and/or handheld remote control must be
used for fan to operate.
If you do
not
wish to use the wall control,
please proceed to Section 7 below to continue with fan
installation.
]
To install wall control
, remove existing wall switch. Wire one of
the
wall controls with wire connectors provided
as shown in
diagram at right.
*Wrap each wire connector separately with electrical tape as an
extra safety measure. Gently push wires and taped wire
connectors into outlet box.
Install one 12-volt battery (included) in wall control.
IMPORTANT
: Wall control will not function unless battery is
installed.
Since this fan comes with an incandescent bulb, the dimmer
switch (labeled
DIM
and
ON
) has been pre-set to the "ON"
position (
DIM
). If you do not wish to have dimming capability,
please move the switch to the "OFF" position (
ON
).
Select a faceplate (almond or white) and press firmly onto front
of wall control. Attach wall control to outlet box and secure with
screws from original wall switch. Attach plate (included) to wall
control using 2 screws provided with the wall control.
(wiring for wall control)
black (OUT to fan)
green
black
(AC IN from
breaker box)
black
(TO POWER supply)
black
green/
green/
bare
bare
ground
ground
green/
bare
ground
outlet box
wall
control
faceplate
12V battery
dimmer
switch
plate
rod support cap
rod support
rod support
set screw
canopy
yoke cover
rod
8. Rod Support Assembly.
Hook one end of rod to loop on motor housing. Adjust
rod support to top end of rod so it holds the rod in place
and tighten rod support set screw. Allow rod support cap
to rest on rod support.
Install remaining rods in between motor housing and rod
support. If rods fall off easily, re-adjust rod support (by
re-adjusting rod support set screw as described above)
with rods already installed.
loop
motor
housing
