smaller fan
smaller fan
main fan
It is recommended that you test fan before finalizing
installation. Restore power from circuit box and light
switch (if applicable). Test wall control (optional
installation) by locating ON/OFF slider switch on
wall control, then set to the ON position. Test
ROTATION/OFF function of main fan with
button; test smaller fan speeds with different
fan speed buttons and OFF button. Next, locate
remote control. Test smaller fan speeds (and OFF)
with the different fan speed buttons and then
test rotation of main fan (and OFF) as was done
with wall control. If the wall and/or remote control(s)
operate(s) all of the functions of the fan, battery has been
installed correctly in (each) remote. If the wall and/or
remote control(s) do (does) not operate all of the fan
functions, refer to "Troubleshooting" section to solve any
issues before contacting Customer Service.
The tilt angle of the smaller fans may be adjusted up or
down by simply moving them gently up or down.
CAUTION:
To avoid personal injury or damage to the
fan(s), both the main fan and the smaller fans MUST BE
OFF before adjusting the smaller fans up or down.
page 10
12. Testing Your Fan.
11. Remote Control Operation.
ON/OFF
slider switch - turns
wall control
ON or OFF (switch not
functional on handheld remote)
HIGH
button - turns
small fans
to HIGH speed
MED
button - turns
small fans
to MEDIUM speed
LOW
button - turns
small fans
to LOW speed
OFF
button - turns
small fans
OFF
L1
button - turns
light kit
ON/OFF when pressed once; dims
light kit
when pressed and held down
L2
button -
(not applicable for this fan)
button - turns
main fan
ON/OFF (i.e., controls ROTATION of the
ENTIRE fan)
CAUTION
:
The handheld remote control can be programmed to multiple receivers or fans. If this is not desired, turn
wall switch off to any other programmable receiver or fan.
Restore electrical power and then, if using wall control, set slider switch on wall control to the ON position.
Within 60 seconds of turning on the wall control, press and hold the fan
OFF
button on the wall control for 5
seconds (or until light blinks twice or fan blades begin to turn).
Turn power off again for at least 5 seconds
and then turn power back on. Within 60 seconds of restoring the
power, press and hold the
OFF
button on the front of the handheld remote control for 5 seconds (or until
light blinks twice or fan blades begin to turn).
Test the light and fan functions to confirm the learning process is complete--
see Section 12 below.
10. Automated Learning Process./Activating Code.
1
1
-
2
2
-
wall control
1
1
-
2
2
-
handheld
remote control
1
1
-
2
2
-
1
1
-
2
2
-
