Craftex CX901, User Manual

Page: 8 / 12

8
REMOVING JAMMED
NAILS
Sometimes the nail gets jammed. Jammed
nail must be removed before using the
nailer again.
To clear the jammed nail:
Disconnect the air supply to the nailer.
Push and hold the magazine lock, pull the
magazine loader all the way back.
Now, use needle nose pliers to remove the
jammed nail.
If the jammed nail can not be removed,
remove the cap screws securing the driver
guide cover to the nose assembly.
Now, the jammed nail should be visible.
Remove the jammed nail with a pair of
needle nose pliers.
Re-install the driver guide cover, and load a
new nail stick.
Check the safety nose mechanism, before
using the nailer again.
CLEANING
Always keep the nailer clean from dust,
chips, sand and etc, in the air connectors or
into the body.
Use a good solvent to clean the nose
assembly of the nailer and make sure the
nailer is dry before using it again.
WARNING!
Do not use gasoline or flammable liquids
to clean this tool. Vapours in the tool may
ignite, causing the tool to explode.
Failure to do so could result in serious
personal injury or death.