4
Always inspect the stock for any nails,
staples, knots or any other
imperfections before sanding.
For the protection of your eyes, always
wear safety glasses, goggles or face
shield while operating the sander.
Never touch the moving sanding disc.
Keep your hands and fingers away
from the moving sanding disc. If the
work-piece is small or difficult to hold,
use work-piece holding fixture.
Always support the work-piece on the
work table against the rotating
direction of the sanding sleeve.
All guards must be in place while
operating the sander to avoid any
injuries.
Do not use excessive force or jam a
work-piece against the sanding
surface. This can cause kick back or
damage to the machine.
Always sand work-pieces which are
stable and if you have any doubt about
the stability of the material, do not
sand it.
Make sure before making any
adjustments, the switch is in the “OFF”
position and the cord is un-plugged.
Never leave the sander unattended
while it is running.
Do not use the sanding sleeves that are
damaged or if the adhesive is not
sticking firmly. If the sanding sleeve
comes off during operation, it might
cause damage to the work-piece or
injury to the operators fingers.
Always use the table insert that fits
closest to the diameter of the installed
sanding drum. A pinch hazard exists
from the gap between the table and the
sander. Always keep this gap as small
as possible.
Do not wear loose clothing, neckties,
jewelry or gloves that can get caught in
moving parts. Confine long hair and
keep sleeves above the elbow.
Make sure you have read and
understood all the safety instructions in
the manual and you are familiar with
your sander, before operating it. If you
fail to do so, serious injury could occur.
CX508 – 14" OSCILLATING SPINDLE SANDER
SPECIFIC SAFETY INSTRUCTIONS
WARNING!
The safety instructions given above can not be complete because the environment in
every shop is different. Always consider safety first as it applies to your individual
working conditions
.
