10
SANDING DRUM/SLEEVE
INSTALLATION
To install the sanding drum and sleeve:
Make sure the cord is disconnected from
the power source.
Hold the sanding drum and sleeve with one
hand and use the second hand to loosen
and remove the spindle lock nut.
Remove the spindle washer, sanding
sleeve, sanding drum, table insert.
Figure-5 Removing/Installing sanding drum
and sleeve
Clean the dust or debris on the table
opening.
Choose the correct size sanding drum,
sanding sleeve and table insert.
Install the desired sanding drum on the
spindle shaft, followed by the sanding
sleeve on the drum as shown in figure-5.
Secure the sanding drum with the
approximate spindle washer and spindle
lock nut. Tighten until the rubber sanding
drum places slight pressure on the sanding
sleeve.
TEST RUN
Once you have mounted your machine, it is
then time for a test run to make sure that
the machine works properly and is ready for
operation.
To test run the machine:
Make sure you have read and understood
the instructions given in the manual.
Remove and clear away all the tools and
objects from the machine.
Connect the cord to the power source and
turn ON the machine.
During the test run if there is any unusual
noise coming from the machine or the
machine vibrates excessively, shut off the
machine immediately and disconnect the
cord from the power source. Check all the
parts you have assembled, once again and
investigate to find out the problem.
If the machine runs smoothly with little or no
vibration, then it is operating correctly.
Turn OFF the sander.
Remove the switch disabling key from the
ON/OFF switch.
Try to turn ON the machine.
If the machine starts, immediately stop the
machine and unplug the cord from the
power source. Do not run the machine until
this safety feature is fixed.
If the machine does not run, it means the
switch disabling key is working properly and
test is complete.
