Craftex CX507, User Manual

Page: 9 / 23

9
TEST RUN
Once you have assembled your sander
completely, it is then time for a test run to
make sure that the machine works properly
and is ready for operation.
During the test run if there is any unusual
noise coming from the machine or the
machine vibrates excessively, stop the
machine immediately and disconnect from
the power source. Investigate to find out the
problem with your machine.
TO TEST RUN THE CX507:
1. Make sure you have read the manual
and understood all the safety
instructions given in it.
2. Remove all the tools and objects from
the machine, used during set up and
assembly.
3. Make sure the sanding drum is safely
above the conveyor belt so that it will
not make contact when running.
4. Connect the power cord to the matched
outlet and push the ON button.
5. Rotate the conveyor variable feed rate
dial clockwise to check if the conveyor
belt feed rate changes. Then turn it
counter-clockwise until the belt stops.
6. Turn the machine OFF.
7. Remove the switch disabling key shown
in figure-7.
Figure-7 Switch disabling key
8. Remove the switch disabling key shown
in figure-7.
If the machine does not start, the switch
disabling features is working.
If the machine starts, immediately stop the
machine. The switch disabling feature is not
working correctly.
ADJUSTMENTS
The adjustments below have already been
performed at the factory prior to shipping.
However, during shipping some parts might
get out of adjustment, and we recommend
you to at least verify the following
adjustments to ensure the best possible
results from your sander.

Conveyor Belt Tension and Tracking

Gib Adjustment

Conveyor Belt to Drum Alignment
WARNING!
Before the test run make sure the switch
is in the OFF position and the cord is
disconnected from the power source.
Failure to do so, could result in serious
personal injury.