Craftex CX503, User Manual

Page: 11 / 18

11
ON/OFF SWITCH
The CX503 features an ON/OFF switch
located on the right side of the motor. The
switch has a big red stop paddle for
immediate shut off and a green start button
to turn on the machine. The start button is
designed to prevent accidental start up.
Figure-11 On/Off Switch
TEST RUN
Once you have assembled your sander
completely, it is then time for a test run to
make sure that the machine works properly
and is ready for operation.
Remove all the tools used for assembling
the machine and make sure all the guards
are in place and secure.
Connect the machine to the power source
and push the start button in to turn the
machine on.
If you hear any unusual noise(s) coming
from the machine or if it vibrates
excessively, shut the machine OFF
immediately and disconnect from the power
source. Investigate to determine the
problem with your machine. For
troubleshooting see page-15.
ANGLE ADJUSTMENT
The sander can be adjusted through
arrange of angles from 0° to 60° for
different sanding operations.
To adjust the sander angle:
Turn the machine OFF and disconnect the
cord from the power source.
Loosen the angle adjustment lever.
Position the sander in the desired angle on
the stand and re-tighten the angle
adjustment lever.
WARNING
Do not make any adjustments while the
machine is running. Turn the machine
OFF and un-plug the cord from the
power source before making any
adjustments. Failure to do so may cause
serious personal injury.
WARNING
Before starting the sander, make sure
that you have read and understood the
manual and you are familiar with the
functions and safety features on this
machine. Failure to do so may cause
serious personal injury.
Use personal safety equipments like
safety goggles, gloves and hearing
protection while operating the machine.