Craftex CX208, User Manual

Page: 13 / 31

13
INSTALLING BLADE
GUARD
Turn the machine OFF and make sure the
cord is unplugged from the power source.
Loosen the lock lever know shown in figure-
13.
Insert the spreader into the mounting block
and tighten the lock lever. See figure 13.
Figure-13 Using knurled knob to secure the
spreader
Make sure the spreader is locked properly.
The blade guard should move freely and
touch the table surface and should swing
high enough to allow the work-piece fed
easily while cutting operation.
Figure-14 Blade guard installed
CONNECTING TO A DUST
COLLECTOR
CX208 features a 4” diameter dust port to
connect to a dust collector.
When connecting to a dust collector, use a
proper sized hose and make sure all the
connections are sealed tightly.
It is recommended to use a proper sized
dust collector with the CX208 to ensure
adequate dust collection.
Figure-15 CX208 dust port
WARNING!
The fine dust particles produced by the
table saw can go into your lungs and
cause serious respiratory problems.
Make sure to wear a dust mask and
connect the table saw to a proper dust
collection system while operating it.