Craftex CX125, User Manual, Page: 9 / 34

9
PLUG AND GROUNDING
REQUIREMENTS
This machine must be grounded so that in
the event of certain malfunctions it will
reduce the chances of electrical shock by
providing a path of lesser resistance for the
electric current to travel through. For this
reason the CX125 comes with a cord
equipped with an equipment grounding wire
that leads in to the grounding prong on the
plug.
NOTE
The three prong plug is only to be plugged
in to the matching receptacle that is
properly installed according to the local
electrical codes and standards. Under no
circumstances should you modify the plug
to make it fit in a receptacle that is not
meant for this configuration. ( see figure 1)
Figure 1
If there is an improper connection of a
machine grounding wire it may result in a
heightened risk of electric shock. If repair or
replacement of the power cord is necessary
in the future please consult a licensed
electrician.
NOTE
If ever you notice damage or wear to either
the cord or plug disconnect it immediately
from the power supply and have it replaced
by a licensed electrician or service tech
before any further use of the machine.
USE WITH EXTENSION CORDS
If you absolutely must require the use of an
extension cord with your machine do so, on
a temporary short term basis only.
NOTE
1. We recommend that you do not use an
extension cord with this machine. Also the
longer the extension cord the greater the
possibility of voltage drop causing the motor
to work harder under powered which in turn
will cause it to draw more amps.
This may
cause the thermal overload to trip or even
the breaker in your electrical panel. It may
also cause the extension cord to heat up
which can be a potential fire hazard.
2. If an extension cord is used with this
machine it must have a ground wire with a
plug that matches the one currently
installed on your machine. The extension
cord must also meet the following
specifications below:
Minimum Wire Gauge: 12 AWG
Maximum Cord Length: 50 ft.