9
ASSEMBLY
Follow the steps below to assemble your
band saw:
Take the band saw table and put it upside
down on floor and make sure that all the
table bolts shown in the figure are tight.
See figure-4
Figure-4 Table trunion bolts
Now attach the table extension to the table
using washers, nuts and bolts, making sure
that the tables are firmly attached to each
other.
Figure- 5 Installing the extension table
Now turn the table up right, and remove the
table pin from the table slot and the table
insert (if already installed) and move the
table in position around the blade, guiding
through the table slot. See figure-6
Figure-6 Installing the table
Position the table on the base in such a
way that the bolts under the table extend
through the holes on the base. Thread the
two knobs on the bolts (do not tighten). See
figure-7.
Figure-7 Knobs threaded on the bolts
Position the table on the table stop and the
base so that the table is perpendicular to
the blade. See page 15 for details.
