7
can cause severe burns.
•
Never leave the CraftBot 3D printer unattended while it is plugged in, and is in
operation.
•
Make sure that the power supply is off and that the power cord is disconnected
before servicing. Allow at least 5 minutes for the device to cool down after
unplugging it before reaching inside to service.
•
Always turn off the printer and disconnect from the computer when it is not being
used.
•
Make sure to level the build plate properly before use.
•
Make sure not to force anything, whether it be during unpacking, setup, operation
or service.
•
Service and oil the suggested parts as often as recommended. Only use only
substances recommended by CraftUnique.
•
The CraftBot 3D printer melts plastic during printing. Plastic odors/gases are
emitted during this operation. Make sure to set up the CraftBot 3D printer in a
well-ventilated area.
Summary of Contents for CB4 FLOW Series
Page 1: ...V 1 0 2020 01 22...
Page 41: ...41...
