Existing House
Skyview Hanger
Beam
S
k
y
v
ie
w
H
-B
e
a
m
S
k
y
v
ie
w
H
-B
e
a
m
3. Determine anchor spacing and pre-drill Wall Hanger accordingly. Attach Wall Hanger/Skyview
Hanger assembly to house. Follow Craft-Bilt anchor tables and connection details or as
determined by your designer, architect or engineer. See drawing at the end of this guide for
more details. Mounting height is determined by using 1:12 pitch minimum, however 2:12 is
ideal for multi-wall sheets.
Follow this section if you are installing a patio cover.
1. Cut the Beam to the same length as Hanger. (see “Notes” regarding splicing). Cut
columns to required height.
2. Erect your columns and the Beam assembly, brace temporarily. Columns and beam
design must meed local code. If you are using Craft-Bilt columns and beam follow our
load tables and column spacing based on your local snow loads.
3. Your connection of the columns to your floor and beam must meet local codes. If you
are using Craft-Bilt columns and beam follow our connection details.
4. Place first H-beam in position making sure everything is square and plumb. Push H-
Beam into Hanger as far as it will go. Fasten H-Beam to Hanger and Beam as shown
with #10 x ½" S.S. tek screws. Repeat for last H-beam. Remove bracing.
4. Install the H-beams using the screw placement shown.
Page 5 Aug 1 2018
Screw placement:
In
Hanger
On front
beam /
wall
