To Open the Door Manually
Trolley
Release Arm
(In Manual
Disconnect
Position)
Emergency
Release Handle
(Down and Back)
Trolley
Lockout position
(Manual disconnect)
To reconnect
Trolley
Release
Arm
Trolley
DISCONNECT THE TROLLEY
1. The door should be fully closed if
possible.
2. Pull down on the emergency release
handle so the trolley release arm
snaps to the vertical position. The
door can now be raised and lowered
as often as necessary.
TO RE-CONNECT THE TROLLEY
1. Pull the emergency release handle
toward the garage door opener so
the trolley release arm snaps to the
horizontal position. The trolley will
reconnect on the next UP or DOWN
operation, either manually or by
using the door control or remote
control.
To prevent possible SERIOUS INJURY or DEATH from a falling
garage door:
l
If possible, use emergency release handle to disengage
trolley ONLY when garage door is CLOSED. Weak or broken
springs or unbalanced door could result in an open door
falling rapidly and/or unexpectedly.
l
NEVER use emergency release handle unless garage doorway
is clear of persons and obstructions.
l
NEVER use handle to pull door open or closed. If rope knot
becomes untied, you could fall.
Care of Your Opener
MAINTENANCE SCHEDULE
Every month
l
Manually operate door. If it is unbalanced or binding, call a
trained door systems technician.
l
Check to be sure door opens and closes fully. Adjust if
necessary, see page 30.
l
Test the safety reversal system. Adjust if necessary, see
page 32.
Every year
l
Oil door rollers, bearings and hinges. The garage door opener
does not require additional lubrication. Do not grease the door
tracks.
l
Test the battery backup and consider replacing the battery to
ensure the garage door opener will operate during an electrical
power outage, see page 33 to test the battery backup.
THE REMOTE CONTROL BATTERY
To prevent possible SERIOUS INJURY or DEATH:
l
NEVER allow small children near batteries.
l
If battery is swallowed, immediately notify doctor.
To reduce risk of fire, explosion or chemical burn:
l
Replace ONLY with 3V CR2032 coin batteries.
l
DO NOT recharge, disassemble, heat above 212°F (100°C) or
incinerate.
1
2
3
Pry open the case first in the
middle (1), then at each side
(2 and 3) with the visor clip.
The Lithium battery should produce
power for up to 3 years.
To replace battery, use the visor clip or
screwdriver blade to pry open the case
as shown. Insert battery positive side
up (+).
Replace the battery with only 3V
CR2032 coin cell batteries. Dispose of
old battery properly.
NOTICE: To comply with FCC and/or Industry Canada (IC) rules, adjustment or modifications of this
transceiver are prohibited. THERE ARE NO USER SERVICEABLE PARTS. Any changes or modifications not
expressly approved by the party responsible for compliance could void the user’s authority to operate
the equipment.
This device complies with Part 15 of the FCC rules and IC RSS-210. Operation is subject to the following
two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation. This Class B digital
apparatus complies with Canadian ICES-003.
AVIS : Les règles de la FCC et/ou d’Industrie Canada (IC) interdisent tout ajustement ou toute modification
de ce récepteur. IL N’EXISTE AUCUNE PIÈCE SUSCEPTIBLE D’ÊTRE ENTRETENUE PAR L’UTILISATEUR. Tout
changement ou toute modification non expressément approuvé par la partie responsable de la conformité
peut avoir pour résultat d'annuler l'autorité de l’utilisateur de faire fonctionner l’équipement.
Cet appareil est conforme aux dispositions de la partie 15 du règlement de la FCC et de la norme IC RSS-
210. Son utilisation est assujettie aux deux conditions suivantes : (1) ce dispositif ne peut causer des
interférences nuisibles, et (2) ce dispositif doit accepter tout interférence reçue, y compris une
interférence pouvant causer un fonctionnement non souhaité. Cet appareil numérique de la classe B est
conforme à la norme NMB-003 du Canada.
41
