Crafco SUPER SHOT 60, Parts Manual

Page: 79 / 140

Super Shot 60 Propane Melter Part Manual
Chapter 8 Troubleshooting
©2018 by Crafco, Inc. All Rights Reserved
………………...…………………………..……………...Illustrated Parts List 8-13
Step Possible Cause If . . .
4 Check for 12Vdc at red wire labeled Red Lid
and pink wire labeled Pink-3 on terminal
block right side upper corner and a nearby
ground source (black wire).

Yes on both, check for loose connections or
broken wires between lid switch and
terminal block.

No on Red Lid and Yes on Pink-3, ensure
both wires are securely installed in the
terminal block.

No, go to step 4a.
4a Is there 12Vdc between the Material
PAKSTAT terminal #2 pink wire and terminal
#8 black ground wire?
(Refer to Fig. 8-3 Mixer Schematic .)

Yes, check for loose connections or broken
wires between PAKSTAT terminal #2 and
terminal block.

No, go to Step 4b
4b Is there 12Vdc between the Material
PAKSTAT terminal #1 orange wire and
terminal #8 black ground wire?

Yes, replace the Material PAKSTAT.

No, go to Step 4c.
4c Is there 12Vdc between orange wire labeled
ORN-1, terminal #9 and terminal #8 ground
source (black wire)?

Yes, check for loose connections or broken
wires between terminals #8 and #1.

No, go to step 5.
5 Is there 12Vdc at orange wire labeled ORN-1
and ORN-2 on the upper terminal block?

Yes on both, check for loose connections or
broken wires between terminal block and
material PAKSTAT.

Yes on ORN-2 and No on ORN-1 replace
terminal block.

No on both, go to step 6.
6 Is there 12Vdc between orange wire labeled
ORN-2 terminal #3 and terminal #5 black
ground of hot oil PAKSTAT?

Yes, check for loose connections or broken
wires between terminal #3 and terminal
block.

No, go to step 7.
Table 8-14 Mixer Electrical Troubleshooting (continued)