Crafco SS60-Diesel, Manual

Page: 52 / 119

Super Shot 60 Diesel Melter Part Manual
Chapter 8 Troubleshooting
©2016 by Crafco, Inc. All Rights Reserved
………………...………………………………..……………...Troubleshooting 8-4
Step Possible Cause If . . .
7a Is there 12Vdc between terminal #3 orange
wire and terminal #8 black wire of the
material PAKSTAT?

Yes, replace PAKSTAT.

No, go to step 7b.
7b Is there 12Vdc between terminal #1 orange
wire and terminal #8 black wire of the
material PAKSTAT?

Yes, check for loose or broken wires
between terminal #1 and #3 of material
PAKSTAT.

No, go to Step 7c.
7c Is there 12Vdc between terminal #9 orange
wire and terminal #8 black wire of the
material PAKSTAT?

Yes, check for loose or broken wires
between terminal #9 and #1 of material
PAKSTAT.

No, go to Step 8.
8 Is there 12Vdc between orange wire labeled
“ORN-1” on upper terminal blocks and a
nearby ground source (black wire)?

Yes, check for loose or broken wires
between terminal #9 of the material
PAKSTAT and terminal block.

No, go to Step 8a.
8a Is there 12Vdc between orange wire labeled
“ORN-2” on upper terminal blocks and a
nearby ground source (black wire)?

Yes, replace terminal block.

No, go to Step 9.
9 Is there 12Vdc between terminal #3 orange
wire and terminal #5 black wire on hot oil
PAKSTAT?

Yes, check for loose or broken wires
between terminal #3 of the hot oil PAKSTAT
and terminal block.

No, go to Step10.
10 Is there 12Vdc between top terminal (orange
wire) of power switch and nearby ground
source (black wire)?

Yes, check for loose or broken wires
between top terminal power switch and
terminal #3 of the hot oil PAKSTAT.

No, go to Step 11.
11 Is there 12Vdc between bottom terminal (red
wire) of power switch and nearby ground
source (black wire)?

Yes, replace switch.

No, go to Step 12.
12 Is there 12Vdc between top terminal of circuit
breaker (red wire) and nearby ground source
(black wire)?

Yes, check for loose or broken wires
between top terminal of circuit breaker and
bottom terminal (red wire) of power switch.

No, go to Step 12a.
Table 8-5 Burner Electrical Troubleshooting (continued)