Crafco SS60-Diesel, Manual

Page: 35 / 119

Super Shot 60 Diesel Melter Part Manual
Chapter 6 Maintenance Instructions
©2016 by Crafco, Inc. All Rights Reserved
………………..…………………………………..….…Maintenance Instructions 6-1
6.0 Maintenance Instructions
This chapter contains all normal maintenance instructions to properly maintain your machine.
6.1 Engine
Refer to the manufacturer
’s operating and maintenance instructions for the engine.
6.2 Hydraulic System
Check hydraulic fluid daily.
Change hydraulic filter every 250 hours of machine operation. Replace if necessary.
Change hydraulic fluid every 500 hours of operation.
6.3 Heat Transfer Oil
Check the oil level at the start of every day.
Change the oil every 500 hours of machine operation or 1 year, whichever comes first. Failure to
follow this oil change interval will result in machine damage.
6.4 Wheel Bearing
Pack the wheel bearing every 24,000 miles or every two years, whichever comes first. Use a good
grade of bearing grease.
6.5 Material Sensor Tube
Check for heat transfer oil in tube every 50 hours of operation. 2 ounces required.
6.6 Lug Nuts
Torque all nuts/bolts before first road use and after each wheel removal. Check and torque after
the first 10 miles, 25 miles, and again at 50 miles. Check periodically thereafter.
Torque in stages as follows:
First stage 20-25 foot-pound (ft-lb)
Second stage 50-60 foot pound (ft-lb)
Third stage 90-120 foot pound (ft-lb)
Tighten bolts and nuts in the sequence shown in Figure 6.1 Lug Bolt Tightening Sequence.
Figure 6.1 Lug Bolt Tightening Sequence
4-BOLT 5-BOLT 6-BOLT
1
2
3 4
1
2
3 4
5
1
2
3
4 5
6