20
SERVICE AND MAINTENANCE INSTRUCTIONS
For longer engine life the Model 200 has been fitted with a High Capacity Air Cleaner
(primary) and secondary element. Due to the dusty conditions created during operation, it is
necessary to service the air cleaner when it becomes clogged with dirt.
To change the primary air cleaner element, loosen the clamp and remove the air cleaner cap.
1.
Service element only when restriction indicator reaches the service level (indicator
pops up). It is only above that point that air cleaner restriction begins to reduce engine
performance level. When restriction finally indicates a change, remove the primary
element carefully. When element replacement is needed use Crafco 31334 (Kohler 25-
083-01)
2.
Do not attempt to clean the dirty element. Rapping, or pounding dirt out is dangerous
and could cause damage to the element.
3.
Carefully check new element for damage before installing.
4.
Reinstall new element, replace air cleaner cap and fasten retaining clips.
Check the secondary element (safety) only if the primary air cleaner element was damaged.
1.
Remove the air cleaner cover.
2.
Remove the primary element.
3.
Remove the safety element
4.
Handle new elements carefully: do not use if the sealing surfaces are bent or damaged.
5.
Reinstall the new safety element, primary element and air cleaner cap. Fasten retain-
ing clips
6.
When element replacement is necessary, order Crafco P/N 31345 (Kohler
25-083-04)
Check engine oil daily. Change oil after every 100 hours of operation. Change oil filter every
200 hours. Use Crafco P/N 31330 or Kohler P/N 12-050-01. (Refer to engine owners
manual).
Check engine oil daily. Change oil after every 100 hours of operation. Change oil filter every
200 hours. Use Crafco P/N 31330 or Kohler P/N 12-050-01. (Refer to engine owners
manual.)
Check fluid level in battery regularly.
Every 50 hours of operation clean out cooling fins on engine. If dust is allowed to accumulate
overheating may occur, causing damage to the engine.
Lubricate cutter shaft bearings every 100 hours using multi-purpose grease.
Lubricate frame pivot every 50 hours using multi-purpose grease.
Tighten all bolts on machine frequently.
Summary of Contents for 200
