12
5.
When cutters will no longer cut to desired depth, they must be replaced. Refer to cutter
changing section on Page 25.
6.
Governor speed in factor set for the most efficient cutting action. Increasing engine
speed may hinder cutter action and also void warranty.
ENGINE OPERATING INSTRUCTIONS
Cold Weather Starting Hints
1.
Be sure to use the proper engine oil for the temperature expected. See Kohler Owners
Manual for recommended SAE Viscosity Grades.
2.
Set speed control at part throttle position.
3.
A warm battery has much more starting capacity than a cold battery.
4.
Use fresh winter grade fuel.
NOTE:
Winter grade gasoline has a higher volatility to
improve starting. Do not use gasoline left over from summer.
Starting
1.
For a Cold Engine:
Place the throttle control midway between the
“slow”
and
“fast”
positions. Place the choke control into the
“on”
position.
For a Warm Engine (normal operating temperatures):
Place the throttle control
midway between the
“slow”
and
“fast”
positions. Place the choke control into the
“on”
position.
2.
Start the engine by activating the key switch. Release the switch as soon as the engine
starts.
NOTE:
Do not crank the engine continuously for more than 10 seconds at a time.
If the engine does not start, allow a 60 second cool down period between
starting attempts. Failure to follow these guidelines can burn out the
starter motor.
NOTE:
Upon start up a metallic ticking may occur. This is caused by the
hydraulic lifter leakdown during storage. Run the engine for 5 minutes.
The noise will normally cease in the first minute. If noise continues, run
the engine at mid throttle for 20 minutes. If noise persists, take the en-
gine to your local Kohler Service outlet.
NOTE:
If the engine develops sufficient speed to disengage the starter, but does
not keep running (a false start), the engine rotation must be allowed to
come to a complete stop before attempting to restart the engine. If the
starter is engaged while the flywheel is rotating, the starter pinion and
flywheel ring gear may clash, resulting in damage to the starter.
If the starter does not turn the engine over, shut off starter immediately. Do not make
further attempts to start the engine until the condition is corrected. Do not start using
another battery. See your Kohler Engine Service Dealer for trouble analysis.
Summary of Contents for 200
