CradlePoint MBR1000 | USER MANUAL Firmware ver. 1.6.9
© 2010
CRADLEPOINT, INC. PLEASE VISIT
HTTP://KNOWLEDGEBASE.CRADLEPOINT.COM/
FOR MORE HELP AND RESOURCES
PAGE 68
Step 3: Wireless Channel.
Go to the
Basic
→ Wireless
sub-menu. Uncheck the
Random Channel Select
check
box and set the channel to a specific channel. If you are
connecting an MBR1000 (repeater) to a CTR or PHS
(WAN), you need to set the MBR1000 to
Mixed 802.11g
and 802.11b
, which makes it stop broadcasting in 802.11n
mode. NOTE: Make a note of the channel you have
selected, as you will need to specify the same channel in
the router with the WAN connection. Click
Save Settings
,
when prompted to
Reboot
or
Continue
, select
Continue
.
Step 4: Enable WDS.
Go to the
Advanced
→ Advanced
Wireless
sub-menu. Check
WDS Enable
and enter the
MAC address of the WAN Router. Click
Save Settings
and
when prompted to
Reboot
or
Continue
, click
Reboot
.
Step 5: WAN Router.
Repeat steps 3 and 4 on the router
with the WAN connection. Substitute the MAC address of
the WAN router with the MAC address of the repeater
router. After the routers have rebooted, the WDS peering
process will initiate and after approximately 2 minutes, the
devices should “see” each other. The router with the WAN
connection will serve DHCP through the repeater router.
Wireless clients that log in to either router should allow you to access the other router as well as the Internet.
Summary of Contents for WIPIPE MBR1000
Page 1: ......