CPMG Magma M1, Owner'S/Operator'S Manual

Page: 6 / 48

6
NOTE: This general outline will only familiarize you with the machine. Read through the en-
tire manual before putting this machine into operation.
1) Access Port: The sealing wand is placed in here when not in use. This allows operator to
continue circulating material through the hose to prevent material from cooling and freezing
up.
2) Loading Door (1 on Model 150): Place the material on safety door to load the melting tank.
3) Oil Temperature Gauge: Monitors the heat transfer oil temperature.
4) Material Temperature Gauge (optional): This gauge shows the temperature of material in-
side the melting tank. This gauge is for reference before pumping starts. Once pumping be-
gins, material controller will be an exact reading of material passing through the system. (Not
shown)
5) Micropanel ignition Switch: Use the key to turn the engine on and off.
6) Pressure Gauge: This gauge measures the pressure required to turn the agitator and the
material pump.
7) Sealing Hose Valve: This valve stops the material recirculating back into the material tank
causing it to go out of the wand.
8) Control Panel: The main control panel is used to control the direction of the material pump
and agitator, and you can also monitor the temperature of the material and heat transfer oil.
Controls and Their Functions