5
Name
Pin function
Description
WCLK
GIO6
Digital I/O
1
I2S/DSP audio interface word clock (in/out)
General-purpose digital I/O pin 6
AD0
GIO7
Digital I/O
1
I2S/DSP audio interface data line 0 (in/out)
General-purpose digital I/O pin 7
AD1
GIO8
Digital I/O
1
I2S/DSP audio interface data line 1 (in/out)
General-purpose digital I/O pin 8
AD2
GIO9
Digital I/O
2
I2S/DSP audio interface data line 2 (in/out)
Configurable with PurePath™ Wireless Configurator
1
Digital I/O pad with 4 mA source/sink capability.
2
Digital I/O pad with 20 mA source/sink capability.
6. Regulatory Notices:
Federal Communication Commission Interference Statement
:
This device complies with part 15 of the FCC rules. Operation is subject to the following
two conditions
(1) This device may not cause harmful interference and
(2) This device must accept any interference received, including interference that may
cause undesired operation
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation.This
equipment generates, uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user
is encouraged to try to correct the interference by one of the following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help.
FCC Caution:
To assure continued compliance, any changes or modifications not expressly
approved by the party responsible for compliance could void the user's authority to operate
this equipment. (Example - use only shielded interface cables when connecting to computer
or peripheral devices).
