STEP 2
Large side of
gasket* on
INTERIOR
of pool.
Small side of
gasket* on
EXTERIOR
of pool.
Pool wall
Pool Liner
and centered
on riser
4-1/2”
from top
of riser
STEP 1
STEP 1A
INSTALLATION ON A
POOL STEP
KEEP STEPS AND LIGHT DRY DURING INSTALLATION
Follow STEP
instructions
for assembly
INSTALLATION ON THE
WALL
OF ABOVE-GROUND POOL
To be performed by an authorized dealer ONLY
*GASKET SOLD SEPARATELY
STEP 1
Using a 2” (50.8mm) cutting
devise, drill a hole in the second riser
from the top at 4-1/2” (114.3mm) from
the top at center.
STEP 1
Using a 2” (50.8mm) cutting devise,
drill a hole through the pool wall and liner.
STEP 1A
Insert the gasket from the inside
of the pool through the 2” hole in the wall,
having the large diameter inside the pool
and the small diameter on the outside.
STEP 2
Thread the electrical cord
through the hole (as shown).
STEP 2
Thread the electrical
cord through the hole (as
shown).
IMPORTANT:
LOWER
THE WATER
LEVEL OF
THE POOL
18”+
2” diameter hole,
MORE THAN 18”
(45cm) below
normal water level
STEP 1
STEP 2
By: Champlain Plastics Inc.
87 Pillsbury Road, Rouses Point, NY 12979
INS-ACM125-rev3E
www.champlainplastics.com
09-2019
ACM-125 & ACM-125C
Universal Pool Light