MANTEINANCE MANUAL
AMBRA
pag. 4 di 8
Ver01
–
2021-06-18
RECOMMENDATIONS AND WARNINGS
The electrical installation must be performed by a qualified professional, in compliance with
the technical and safety regulations in force. This pump is not equipped with a thermal switch,
so it must be installed under a thermal relay and differential protection in compliance with the
technical and safety regulations in force. In order to prevent electric shocks in case of damage
to the electrical wiring, always connect the pump to the system ground. (fig. A)
ground connection
docking station
>75 cm
copper rod / bar placed in depth
fig. A
fixing by welding or screw
Do not connect the pump with damp or wet cables. This pump is not self-priming, so do not run the
pump empty. If this happens by mistake, immediately disconnect the power supply, then wait for
the engine to cool and then fill it with clean water. (fig. B)
fig. B
fig. C
Do not cover the motor body with rags or similar, this could cause a fire. Before proceeding with
the installation, check that the moving parts rotate freely: insert a screwdriver into the recess of the
motor shaft on the side of the fan protection grid and try to rotate the blades (fig. C). If the
movement is difficult to strike gently with a hammer the screwdriver in order to unlock the rotation.
Tampering or modification of the same determine the immediate end of the validity of the
guarantee and can cause serious damage to the machine and to the user.
INSTALLATION
The pump must be installed in a well-ventilated and dry place, protected from bad weather
and exposure to temperatures above 40 ° C. The pump must be installed in compliance with
the EN 60335-2-41 electrical safety standard: any electrical appliance powered at 230 V must
be installed at a minimum distance of 3.5 m from the edge of the pool. The base of the pump
is equipped with holes to be anchored to the ground: fix the pump on a flat and solid surface
by adopting suitable bolts for use to avoid vibrations. The pump must be installed in a
horizontal position in order to allow the correct operation of the bearings. The pipes for
transporting water to and from the pump must be fastened without burdening the connection
points with the pump: