Instruction manual CPL-40
6
of
19
ELECTRICAL
PANEL
SPEED
CHANGE
GRID
PROTECTION
BOWL
LOCKING
HANDLES
INSTRUCTIONS FOR USE
To be able to work; the bowl must be mounted and the bowl protective grid closed. Otherwise it will be
blocked by the safety systems.
DO NOT REMOVE OR TAMPER WITH THE ELECTRICAL OR MECHANICAL GUARDS OR SAFETY
DEVICES ON THE MACHINE.
The bowl must be in position BEFORE the tools. It must be inserted with the bowl
lever down, putting the bowl plate, placed at the back of the bowl, on the bowl lifting
arc.
Complete positioning by having the holes on the bowl support plates match with
the centering pins. Block the bowl with the handles.
If it was not previously done, rotate the protective grid of the bowl
to the open position and, after having chosen the tool, insert it
into the tool holder shaft. Once it is inserted, turn the tool
clockwise, having the transmission pin enter the work position as
indicated in the figure. Lower it and insert the tool lock ring.
Using the arrows é and ê , on the control panel to lift the bowl to the working position and close the
protective grid of the bowl. At this point, after inserting the ingredients, start the work cycle.
