CozyCab A-11289, Mounting Instructions, Page: 6 / 26

05-10433
October 2003
Mounting Instructions
John Deere 2210
HEATER HOSE HOOKUP (Ref. Drawing #8-14751)
20. Drain coolant from radiator and engine block.
21. Remove temperature sensor from thermostat
housing area.
22. Install aluminum fitting #3-15815
with O-ring
washer #3-16823 into thermostat housing. See
Figure 21.
23. Re-install temperature sensor into the
aluminum fitting just installed (Step 20).
24. Install hose to NPT fitting #3-12119 into the
side port of the aluminum fitting.
25. Measure and cut the 5/8” heater hose that
routes (supply line) from the left (driver side) of
the cab to the thermostat-aluminum-hose
nipple fitting. Plastic elbow #3-10282 should be
used at the bottom of the cab tubes. See
Figure 25.
26. The lower radiator hose will need to be cut for
installation of the lower radiator hose “T” fitting
#7-11308. See Figure 25.
27. Install 5/8” hose to NPT fitting #3-12119 into
the lower radiator hose “T” fitting. See Figure
25.
28. Measure and cut the 5/8” heater hose from the
right side (Return Line) of the cab with the 90-
degree elbow #3-10282 to the lower radiator
hose “T” nipple fitting. See Figure 25.
29. Tighten all hose connections with hose clamps.
30. Re-connect Battery Power.
31. Refill radiator. Start engine and run at fast idle
to purge air from coolant system. Make sure
the Heat-Pull Lever is pulled out (Turned On).
32. Check for leaks.
33. Check coolant level after heater core and
hoses are filled.
VERTICAL EXHAUST KIT
34. For applications that require a high exhaust system, over the head of the operator, a vertical
exhaust kit may be available. Check with your local John Deere dealer.
Figure 25
Figure 21
Note 24
Note 22
Note 21 & 23
Note 27
Note 25
Note 26
Page 6 of 26