5
1. Align the hood and center it above the hood mounting bracket. Gently lower the hood until it securely engages the bracket.
2. Level the hood.
3. While the hood is hanging in place, secure it to the wall through both holes located in the upper back of hood
using 2 no. 10-12 x 2½” screws and washers. If required, pre-drill holes before securing the screws.
4. Using at least 1 hole on each side of the lower back of the hood, secure the hood into solid material (wall studs)
using 2 no. 10-12 x 2½” screws and washers. If required, pre-drill holes before securing the screws.
6. INSTALL HOOD MOUNTING BRACKET
If necessary, construct a wall framing using minimum 2” x 4” lumber. Proper
structural support is required to accomodate the weight of the hood.
After the wall surface is finished, measure and mark the center of the
installation; draw the vertical center line up to the ceiling.
Carefully center and level the hood mounting bracket over the installation
location.
Secure it to the wall framing using 3 no. 10-12 x 2½” screws.
7. INSTALL UPPER FLUE MOUNTING BRACKET
8. INSTALL THE HOOD
WARNING
!
When cutting or drilling into wall, do not damage electrical
wiring and other hidden utilities.
Ensure that the wall is solid enough to withstand the weight
of the hood.
NOTE: The upper flue mounting bracket is packed with the decorative
flue, but the mounting bracket screws are in the parts bag of
the hood.
Center the upper flue mounting bracket with the center line drawn in the
previous step and place it flush with the ceiling.
Use the upper flue mounting bracket as a template to mark the position of
the screws.
Secure the upper flue bracket to the wall using 3 no. 10-12 x 2½” screws.
Ensure that the bracket is tight against the wall.
CAUTION
DO NOT REMOVE the protective plastic film covering the decorative flue (upper & lower) yet.
HD1084A
L
OWER
HOLES
LOCATION
U
PPER
HOLES
LOCATION
R
ANGE
HOOD
BACK
VIEW
HD1083A
S
CREW
LOCATIONS
HD0377
C
L
C
EILING
M
OUNTING
BRACKET
FLUSH
WITH
CEILING
WARNING
!
BE CAREFUL when installing the decorative flue and hood, they may have sharp edges.
HD1087
