8
IMPORTANT:
Before connecting grill to gas source, make sure BBQ Grill control knobs are in the “OFF”
position.
•
Verify the type of gas supply to be used, either natural or LP, and make sure the marking on the
appliance rating label agrees with that of the supply.
•
All pipe sealants must be an approved type and resistant to the actions of LP gas. Never use pipe
sealant on flare fittings.
•
The installation of this appliance must conform with local codes or, in the absence of local codes, with
either National Fuel Gas Code, ANSI Z223.1/ NFPA 54, Natural Gas and Propane Installation Code, CSA
B149.1, or Propane Storage and Handling Code, B149.2, or the Standard for Recreational Vehicles, ANSI
A 119.2/ NFPA 1192M, and CSA Z240 RV Series, Recreational Vehicle Code, as applicable.
WARNING:
Gas valves are preset at the factory to operate on LP or natural gas. If you wish to convert, be sure
to contact your grill dealer FIRST!
This propane gas grill is designed to operate on propane gas ONLY, at a pressure regulated at 11” (279.4mm)
water column (W.C.) when equipped with the correct propane orifices on the valves and a propane regulator
on the supply line regulated at the residential meter. The LP gas grill is designed to be used with a standard 20
lbs gas cylinder and must be constructed and marked in accordance with specifications of the US Department
of Transportation for propane gas cylinders.
Always keep cylinder securely fastened in an upright position. Never connect an unregulated propane gas
cylinder to the grill.
Do not subject propane cylinders to excessive heat.
CAUTION:
Never store a LP gas cylinder inside a building or in the vicinity of any gas-burning appliance.
Cylinder Specifications
-
Any L.P. gas supply cylinder used with this grill must be approximately 12 inches diameter and 18 inches
high. The maximum fuel capacity is 80% and is approximately 20 pounds of propane.
-
The L.P. cylinder must have a shut-off valve (see picture) terminating in a Type 1 L.P.
-
A Type 1 compatible cylinder with a Type 1 cylinder valve has a back-check valve which does not permit
WARNING:
Never attach an unregulated gas line to the appliance. Connection to an
unregulated gas line can cause excessive heat or fire.
NOTE: Always have a qualified service technician perform difficult conversions
or modifications.
LP Gas Hook-up
Gas Requirements
Summary of Contents for C1C34
Page 32: ...30 C1C34 Exploded Parts View ...
Page 34: ...32 C1C36 Exploded Parts View ...
