Covidien Newport e360, Service Manual

Page: 41 / 154

Overhaul Procedures
Service Manual 2-17
2.8.7
Emergency Intake Diaphragm
Figure 2-13. Emergency Intake Diaphragm and Valve Replacement
To replace the emergency intake diaphragm, refer to Figure 2-13. and perform the following
steps:
1.
Remove the top cover by following the procedure in section 4.6 , “ Top Cover (CVR2101M) .”
2.
Remove the pneumatics panel by following the procedure in section 4.16 , “ Pneumatics Panel Assembly
and Components .”
3.
Remove the inspiratory flow sensors by following the procedure in section 4.16.2 , “ Air and Oxygen
Inspiratory Flow Sensors (GR-FTD2100P and GR-FTD2101P) .”
4.
Disconnect the green tube from the emergency intake valve nipple.
5.
Remove the two emergency intake valve retaining screws (see Figure 2-13. ).
6.
Remove the cap to the emergency intake valve assembly.
7.
Remove the diaphragm.
8.
Install the new diaphragm (DIA1800M).
9.
Using needle nose pliers, remove the emergency intake valve.
10.
Replace the emergency intake diaphragm (VLV2101M).
11.
Reinstall the assembly by reversing the disassembly procedure.

Note:
If your unit has the old-style intake valve, order FSK2109A for the e360T and e360T+ and FSK2103A for other
models to update the unit.
1 Mixing block 3 Mixing block retaining screws (2)
2 Emergency intake valve assembly 4 Emergency intake valve retaining screws (2)